hohner

    Hohner Corporation
Home Email Distributors Terms About Us Accessories Download 3D AutoCAD

Series IN85 hollow shaft encoder up to 20 mm
IN85

-

 X   X   X   S - X   X   A   0 - X   X   X   X

Shaft size

 

 |   |

|

Resolution - ppr
AA = 1/4"

 

 |   | Output Signal
AB = 3/8" Sealing | 1 = A
AC = 1/2" G = IP54 | 2 = AB
AE = 5/8"   | 3 = ABO
     keyway 3/16" Connection 4 = A & A inv
06 = 6 mm H = 9 pole D 5 = AB & AB inv
08 = 8 mm 6 = cable 2m 6 = A & O
10 = 10 mm 7 = ABO & ABO inv
12 = 12 mm keyway 4 x 4
14 = 14 mm
20 = 20 mm (stainless steel)

Select your options below and buy online, easily and securely, with PayPal (from $225)

 Shaft Size    Sealing   Connection    Output                   Resolution

 

Technical Data Connection Options
Operating temp: - 20 ...+   60 degrees C 9 pole MS Cable
-   4 ...+ 140 degrees F PS GND 1 Black
Higher Temperature: Please consult PS 5 ... 24 V 2 Blue
Max frequency: 100 kHz Output A 3 Brown
Current consumption: 80 mA (max.) Output B 4 Beige
Power supply: 5 - 24V Output O 5 Pink 
Weight:    16 oz (0.45 kg) Output A inv 6 Yellow 
Protection: IP 54 Output B inv 7 Green 
Housing: Plastic Output O inv 8 Violet
Shaft: Aluminum
Bearings: 2 x 6805 ZZ C2 Output
Torque: 0.4 oz/in (3 N-cm) A is 90 degrees before B in clockwise direction
Humidity: Up to 98% permissible

Speed:  3000 RPM max.
Shock: 10g (6msec)
Vibration: 5g (500 Hz)
Shaft load: Radial/Axial max 10 lbs
Line driver output max: 50 mA per channel
Max. ppr 2048
Inertia: 30gm-cm2
Mounting Instructions

Mount fixture to the encoder with three self-tapping no. 8 screws and three no. 8 washers.  Slide the encoder onto the shaft.  With the setscrew, tighten the hollow shaft onto the shaft.  Mount the tether on the machine or motor-frame.  The tether can be bent to adapt to any surface.  This assembly allows the encoder to float and increases the lifetime of the bearings.  Connect the encoder as per wiring specifications.  Make sure power supply is within the proper voltage and current rating.  Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW.  See datasheet for CW and CCW directions of the outputs.

 

Technical data for tether:  0.3 mm stainless steel sheet
Dimensions

Hohner Corp. Tel: (905) 563 4924
5536 Regional Road 81 Fax: (905) 563 7209
Beamsville, Ontario E-mail: hohner@hohner.com
Canada L0R 1B3 Web: www.encoderonline.com