hohner

    Hohner Automation Ltd.
Home Email Distributors Terms About Us Accessories Download 3D AutoCAD

Series 85 incremental hollow shaft encoder up to 20 mm

(non intrinsically safe part number)

 
8 5 X X X X X X / X X X X
|_______| |_______| | | R  E  S  O  L  U  T  I  O  N
Shaft Size | Output Circuit | Up to 1500 ppr max

| |
Output Signal Connection

 
XX

Shaft Size

 XX Output Signal

06 = 6 mm

 31 = channel A
08 = 8 mm 32 = channel A and B
12 = 12 mm 33 = channel A, B and O
20 = 20 mm.......you get the picture..... 34 = channel A and A comp
0D = 3/8" 35 = channel A & B and A & B comp
0E = 1/2" 36 = all six channels
0F = 5/8"
X Output Circuit X Connection
7 = Current Sink / Open Collector 5-24 V R = 2 m cable
9 = Extended Line Driver 5-24 V S = 100mm cable with 12 pin wired to end
D = 9 pole D
E = 3 m cable
F = 4 m cable
G = 5 m cable
H = 8 m cable
2 = 4 pin plug (only possible with 2 channels max)
Technical Data Connection Options
Operating temp: - 20 ...+   60 degrees C 9 pole Cable
-   4 ...+ 140 degrees F PS GND 1 Black
Max frequency: 150 kHz PS 5 ... 24 V 2 Red
Current consumption: 90 mA (max.) Output A 3 White
( Unloaded ) Output B 4 Blue
Power supply: 5 - 24V Output O 5 Yellow
Weight:    16 oz (0.45 kg) Output A inv 6 Green
Protection: IP 54 Output B inv 7 Violet
Housing: Plastic Output O inv 8 Brown
Shaft: Aluminum
Bearings: 2 x 61805 2RZ Output
Torque: 0.4 oz/in (3 N-cm) Diagram is shown with clockwise shaft rotation viewed from 
Humidity: Up to 98% permissible

opposite side to shaft grub screws
Speed:  3000 RPM max.

 
Shock: 10g (6msec)
Vibration: 5g (500 Hz)
Shaft load: Radial / axial max 10 lbs
Line driver output max: 50 mA per channel
Max. ppr 1500
Inertia: 30 gm-cm2
    
Mounting Instructions

Mount fixture to the encoder with three self-tapping no. 8 screws and three no. 8 washers.  Slide the encoder onto the shaft.  With the setscrew, tighten the hollow shaft onto the shaft.  Mount the tether on the machine or motor-frame.  The tether can be bent to adapt to any surface.  This assembly allows the encoder to float and increases the lifetime of the bearings.  Connect the encoder as per wiring specifications.  Make sure power supply is within the proper voltage and current rating.  Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW.  See datasheet for CW and CCW directions of the outputs.

 

Technical data for tether:  0.3 mm stainless steel sheet

Dimensions

Hohner Automation Ltd. Tel: +44 (0) 1978 363-888
Whitegate Industrial Estate Fax: +44 (0) 1978 364-586
Wrexham LL13 8UG E-mail: uksales@hohner.com
United Kingdom Web: www.hohneronline.co.uk